| Opcode / Instruction | Op/En | 64/32 bit Mode Support | CPUID Feature Flag | Description |
|---|---|---|---|---|
| NP 0F AE /4 XSAVE mem | M | V/V | XSAVE | Save state components specified by EDX:EAX to mem. |
| NP REX.W + 0F AE /4 XSAVE64 mem | M | V/N.E. | XSAVE | Save state components specified by EDX:EAX to mem. |
| Op/En | Operand 1 | Operand 2 | Operand 3 | Operand 4 |
| M | ModRM:r/m (w) | NA | NA | NA |
Performs a full or partial save of processor state components to the XSAVE area located at the memory address specified by the destination operand. The implicit EDX:EAX register pair specifies a 64-bit instruction mask. The specific state components saved correspond to the bits set in the requested-feature bitmap (RFBM), which is the logical-AND of EDX:EAX and XCR0.
The format of the XSAVE area is detailed in Section 13.4, “XSAVE Area,” of Intel® 64 and IA-32 Architectures Software Developer’s Manual, Volume 1. Like FXRSTOR and FXSAVE, the memory format used for x87 state depends on a REX.W prefix; see Section 13.5.1, “x87 State” of Intel® 64 and IA-32 Architectures Software Developer’s Manual, Volume 1.
Section 13.7, “Operation of XSAVE,” of Intel® 64 and IA-32 Architectures Software Developer’s Manual, Volume 1 provides a detailed description of the operation of the XSAVE instruction. The following items provide a high-level outline:
1. An exception is made for MXCSR and MXCSR_MASK, which belong to state component 1 — SSE. XSAVE saves these values to memory if either RFBM[1] or RFBM[2] is 1.
Use of a destination operand not aligned to 64-byte boundary (in either 64-bit or 32-bit modes) results in a general-protection (#GP) exception. In 64-bit mode, the upper 32 bits of RDX and RAX are ignored.
RFBM ← XCR0 AND EDX:EAX; /* bitwise logical AND */
OLD_BV ← XSTATE_BV field from XSAVE header;
IF RFBM[0] = 1
THEN store x87 state into legacy region of XSAVE area;
FI;
IF RFBM[1] = 1
THEN store XMM registers into legacy region of XSAVE area; // this step does not save MXCSR or MXCSR_MASK
FI;
IF RFBM[1] = 1 OR RFBM[2] = 1
THEN store MXCSR and MXCSR_MASK into legacy region of XSAVE area;
FI;
FOR i ← 2 TO 62
IF RFBM[i] = 1
THEN save XSAVE state component i at offset n from base of XSAVE area (n enumerated by CPUID(EAX=0DH,ECX=i):EBX);
FI;
ENDFOR;
XSTATE_BV field in XSAVE header ← (OLD_BV AND NOT RFBM) OR (XINUSE AND RFBM);
None.
XSAVE: void _xsave( void * , unsigned __int64);
XSAVE: void _xsave64( void * , unsigned __int64);
| #GP(0) | If a memory operand effective address is outside the CS, DS, ES, FS, or GS segment limit. |
| If a memory operand is not aligned on a 64-byte boundary, regardless of segment. | |
| #SS(0) | If a memory operand effective address is outside the SS segment limit. |
| #PF(fault-code) | If a page fault occurs. |
| #NM | If CR0.TS[bit 3] = 1. |
| #UD | If CPUID.01H:ECX.XSAVE[bit 26] = 0. |
| If CR4.OSXSAVE[bit 18] = 0. | |
| If the LOCK prefix is used. | |
| #AC | If this exception is disabled a general protection exception (#GP) is signaled if the memory operand is not aligned on a 64-byte boundary, as described above. If the alignment check exception (#AC) is enabled (and the CPL is 3), signaling of #AC is not guaranteed and may vary with implementation, as follows. In all implementations where #AC is not signaled, a general protection exception is signaled in its place. In addition, the width of the alignment check may also vary with implementation. For instance, for a given implementation, an alignment check exception might be signaled for a 2-byte misalignment, whereas a general protection exception might be signaled for all other misalignments (4-, 8-, or 16-byte misalignments). |
| #GP | If a memory operand is not aligned on a 64-byte boundary, regardless of segment. |
| If any part of the operand lies outside the effective address space from 0 to FFFFH. | |
| #NM | If CR0.TS[bit 3] = 1. |
| #UD | If CPUID.01H:ECX.XSAVE[bit 26] = 0. |
| If CR4.OSXSAVE[bit 18] = 0. | |
| If the LOCK prefix is used. |
Same exceptions as in protected mode.
Same exceptions as in protected mode.
| #GP(0) | If the memory address is in a non-canonical form. |
| If a memory operand is not aligned on a 64-byte boundary, regardless of segment. | |
| #SS(0) | If a memory address referencing the SS segment is in a non-canonical form. |
| #PF(fault-code) | If a page fault occurs. |
| #NM | If CR0.TS[bit 3] = 1. |
| #UD | If CPUID.01H:ECX.XSAVE[bit 26] = 0. |
| If CR4.OSXSAVE[bit 18] = 0. | |
| If the LOCK prefix is used. | |
| #AC | If this exception is disabled a general protection exception (#GP) is signaled if the memory operand is not aligned on a 64-byte boundary, as described above. If the alignment check exception (#AC) is enabled (and the CPL is 3), signaling of #AC is not guaranteed and may vary with implementation, as follows. In all implementations where #AC is not signaled, a general protection exception is signaled in its place. In addition, the width of the alignment check may also vary with implementation. For instance, for a given implementation, an alignment check exception might be signaled for a 2-byte misalignment, whereas a general protection exception might be signaled for all other misalignments (4-, 8-, or 16-byte misalignments). |